8
SCREEN ICONS
1. Press the power button (11) to turn on the screen.
2. Hold the button (3) for 3 seconds and the screen will display “pairing”.
3. Press the CALL button (4) once on the Outdoor Intercom to turn it on.
4. HOLD the CALL button (4) for 10 seconds on the Outdoor Intercom.
5. “Success” will be displayed on the Monitor to indicate pairing is complete.
6. If pairing did not work then “fail” will be displayed, please repeat step 2, 3 + 4 again.
Outdoor Intercom
1. When a visitor presses the call button (4) of outdoor intercom, the indoor monitor will give a bell tone and activate
the monitor screen. The indoor monitor screen will display a picture of the visitor automatically.
2. Press the Intercom button (3) and speak to the visitor.
3. Press the Exit button (4) to end the call and the screen will switch to standby mode.
Indoor Monitor:
1. The Monitor/Delete button (7) can be used to see who is at the door when the Outdoor CALL button has
not been pressed. (Only available when outdoor intercom is mains powered.)
2. Press the Intercom button (3) and speak to the visitor.
3. Press the Exit button (4) and the screen will switch to standby mode.
Unlock:
1. After identifying the visitor press the Unlock button (10) to unlock the door. (Only for operation with an
electric door opener MAX 12v 1A using separate power supply - Items DB5005 and DB5005L - Not supplied.)
PAIRING
EN
To Next Page
Loading...
