70
TROUBLESHOTTING GUIDE
Case 1. Do no start on
Case 2. Not enough power/Poor accelerator / Unequal idle speed
Case 3. Does not lubricate
If it seems that the chainsaw needs an adittional maintenance, please take it to
the nearest Garland service.
Possibily the carburator is not been fitted
properly.
Take it to the technical service so they can fit the needles
of the carburator
Check that the lubrications orifices are
clean.
Clean them.
Check that the fuel is not in a bad state.
Replace it with a suitable fuel.
Check that the fuel does not leak from
the exhaust
Remove and dry the spark plug.
Check that the fuel is not in a bad plug
Replace it with new plug
Check that the fuel is not in a bad state.
Replace it with a suitable fuel.
Check the air´s filter and the fuel´s filter
are not dry
Clean them
To Next Page
Loading...