28
Tools_System
This section allows you to manage the access point's configuration settings, reboot the access point, and restore the
access point to the factory default settings. Restoring the unit to the factory default settings will erase all settings,
including any rules that you've created.
Save To Local Hard Drive
This option allows you to save the access point's configuration to a file on your computer. Be sure to save the
configuration before performing a firmware upgrade.
Load From Local Hard Drive
Use this option to restore previously saved access point configuration settings.
Restore To Factory Default
This option restores all configuration settings back to the settings that were in effect at the time the access
point was shipped from the factory. Any settings that have not been saved will be lost. If you want to save
your access point configuration settings, use the Save Settings option above.
Reboot The Device
This restarts the access point. Useful for restarting when you are not near the device.
To Next Page
Loading...
Need help?
General
