6-1
Specifications
Model
Specification
IDF1E IDF2E IDF3E IDF4E IDF6E IDF8E IDF11E IDF15E
50Hz 0.1 0.2 0.32 0.52 0.75 1.22 1.65 2.8 Air Flow Rate
m
3
/min (ANR)(Note 1)
60Hz 0.12 0.235 0.37 0.57 0.82 1.32 1.82 3.1
Operating Pressure 0.7MPa
Inlet Air Temperature 35
o
C
Ambient Temperature 32
o
C
Rated Condition
Pressurized Dew Point 10
o
C
Working Fluid Compressed Air
Inlet Air Temperature 5 ~ 50
o
C
Inlet Air Pressure 0.15 ~ 1.0MPa
Operating
Range
Ambient Temperature 2 ~ 40
o
C(Relative Humidity of 85% or less)
100VAC(50/60Hz)
Single phase AC100/100 , 110V［Voltage fluctuations±10%］
Power source
200VAC(50/60Hz)
Single phase AC200/200 , 220V
［Voltage fluctuations±10%］
100VAC(50/60Hz) 18 / 1 6 18 / 1 6 1 8 / 1 6 1 9/ 1 8 1 9/ 1 8 2 2 /2 2 2 8 / 2 6 2 7 / 2 6 Starting current
(Note 2) A
200VAC(50/60Hz) 8 / 8 7 / 8 9/ 8 11 / 1 0 2 1/ 2 0 2 3/ 2 2
100VAC(50/60Hz) 2 . 4 / 2. 5 2 . 4/ 2 . 5 2. 4 / 2 .5 2 . 4 / 2. 5 2. 4 / 2 . 5 3 . 0 / 3. 1 5 . 7 / 5. 7 4 . 3 / 4 . 6Operating urrent
(Note 2) A
200VAC(50/60Hz) 1 . 2/ 1 . 3 1. 2 / 1 . 3 1 . 2/ 1 . 3 1. 5 / 1 . 5 3 . 4/ 3 . 0 3. 4 / 3 .1
Power
consumption
(Note 2) W
100VAC,200VAC
(50/60Hz)
180/202 180/202 180/202 180/202 180/202 208/236 385/440 480/480
100VAC 1 0 A
Electrical Specification
Circuit Breaker
(Note 3)
200VAC 5 A
Condenser Plate fin tube type with forced air cooling
Refrigerant R134a (HFC) (GWP:1300)
Refrigerant Charge(AC100V/200V) g
70±5 115 ±5 150 ±5 180 ±5 200 ±5 250 ±5 260 ±5 350 ±10
Drain Connection Rc3/8 Rc1/2 Rc3/4 Rc1
Drain Connection 10mm
Coating Color
Panel: Urbanwhite 1
Base: Urbangray 2
Weight kg 16 17 18 22 23 27 28 46
Applicable Compressor(Standard) kW 0.75 1.5 2.2 3.7 5.5 7.5 11 15
Note1: The data for l/min (ANR) is referring to the conditions of 20°C, 1atm . pressure & relative humidity of
65%.
Note 2: The value is that of under specified condition.
Note 3: Install cicuit breaker that comes with sensivity of
≤30mA.
6 - 1
To Next Page
Loading...