Fig. 2. Connecting Ethernet cables to SMCPWR-INJ3.
5. Check the “ACTIVE” LED: if power is successfully fed into the
SMC2586W-G, the “AC-TIVE” LED will be on (Red light); otherwise, the
“ACTIVE” LED will be off.
6. If the electricity current is over the normal condition (Io°÷1.0 A), the
“ACTIVE” LED will flash (Red light).
NOTE: SMCPWR-INJ3 is specially designed for “SMC2586W-G
EliteConnect™ 2.4GHz 802.11g Wireless Bridge. The use of SMCPWR-INJ3
with other Ethernet-ready devices that are not compliant to IEEE802.3af
may cause damage to the devices.
2.2 Mounting the SMC2586W-G on a Wall
The SMC2586W-G is wall-mountable.
1. Stick the supplied sticker for wall-mounting.
2. Use a f7.0mm driller to drill a 25mm-deep hole at each of the cross marks.
3. Plug in a supplied plastic conical anchor in each hole.
4. Screw a supplied screw in each plastic conical anchor for a proper depth
so that the SMC2586W-G can be hung on the screws.
5. Hang the SMC2586W-G on the screws.
Fig. 3. Mounting the SMC2586W-G on a wall.
15
To Next Page
Loading...