The relationships among the operational modes and the wireless link
types are shown in the following table:
Table 1. Operational modes vs. wireless link types.
From the table, a WDS link can be establish between two APs, a BM-BS link
can be established between a Bridge Master and a Bridge Slave, but no
wireless link can be established between a Bridge Slave and an AP.
Select an operational mode and click Save at the bottom of this page, and
then you are brought back to the start page.
Step 2: Configuring TCP/IP Settings
Fig. 8. TCP/IP settings.
Go to the TCP/IP Addressing section to configure IP address settings. The
IP address can be manually set or automatically assigned by a DHCP server
on the LAN (Default: DHCP client enabled). If you are manually setting the
IP address, Subnet mask, and Default gateway settings, set them appropri-
ately, so that they comply with your LAN environment. In addition, you can
specify the Host name and Domain (DNS suffix) of the SMC2586W-G.
When you are finished, click Save at the bottom of this page, and then you
are brought back to the start page.
20
To Next Page
Loading...