3
Overview
This product’s design is based on the need for a 3 in 1 work station. It combines a soldering station, a hot
air rework, and a DC power supply. These functions can be used independently or simultaneously. This
design occupies less area and is energy efficient.
The product uses a double-sided fiberglass circuit board. The components are installed in a particular or-
der to eliminate noise from the DC voltage signal.
There are components in the work station that can detect a fault (short circuit, open circuit, overload, etc.)
and prevent damage to the work station.
Soldering Iron and Hot Air Rework Station
The soldering iron, hot air rework station and DC power supply use independent dual-core microcontrol-
lers to allow for each function to work independently. A dual-core CPU is used to avoid failure on one fea-
ture when another feature is not functioning properly.
An Intelligent Fuzzy logic PID controller monitors the temperature of the soldering iron and the hot air re-
work station. This temperature is displayed on the LED digital display. There are components to the de-
vice that help maintain temperature stability.
The hot air rework station uses high quality heating elements which provide double the power efficiency in
comparison to a normal station. This extends the life of the heating elements.
The hot air rework station has two options for the type of fan used: a brushless fan gentle wind and a dia-
phragm pump spiral wind.
The soldering iron has an anti-static design and RF protection to prevent electrostatic damage to the SMD
components.
Hot Air Rework Staon
Soldering Iron
Features
To Next Page
Loading...