Instructions for the user
36
5.6 Running a program
From the “OFF” status proceed as follows:
1 Turn the knob to the or symbol to select one of the available
programs from P01 to P38. The display will show the parameters of the
selected program in rotation. To start the program press the “START” button.
The appliance will perform a preheating cycle, showing the text “PrEh”on
the display.
2 When preheating is finished, a series of beeps lasting 3 seconds will indicate
that is possible to proceed with the cooking operation. The text “PrEh” will
flash on the display.
3 To start cooking, keep the “START” button pressed for 2 seconds. The
display will show the set parameters in sequence, with the time remaining
until the end of cooking and the program selected.
4 It is possible to start cooking early before the preheating temperature is
reached, by keeping the “START” button pressed for 3 seconds.
5 During the last minute of cooking, only the countdown of the remaining 60
seconds will be displayed. At the end, a beep and the text “End” flashing (for
20 minutes) will indicate that cooking has been completed.
6 To return to the “OFF” status keep the “STOP” button pressed for 4 seconds.
During cooking, if it is necessary to open the oven door, the display shows the
message “door” together with a continuous acoustic signal. When the door is
closed the oven will continue cooking.
To Next Page
Loading...
