Instructions for the user
35
5.5 Editing / saving a program
The oven has 38 programs that can be modified by the user (from P01 to P38).
To set the operating parameters of a program:
1 Turn the knob to the or symbol to select the program you wish to save
/ edit.
2 Keep the “PUSH” knob pressed for 3 seconds: the display will show the
cooking temperature.
3 Turn the knob to the or symbol to set the cooking temperature.
4 Press the “PUSH” knob: the display will show the cooking time.
5 Turn the knob to the or symbol to set the cooking time (from 1 to 99
min).
6 Press the “PUSH” knob: the display will show the level of oven
humidification (humidified models only).
7 Turn the knob to the or symbol to set the level of humidification H0,
H1, H2 or H3. Set H0 if oven humidification is not required.
If the temperature is set below 110°C, no oven humidification level can be set.
8 Press the “PUSH” knob to exit from the data setting and saving phase. The
message “PEnd” will appear on the display and the parameters will be
saved.
9 After 3 seconds the display will show the parameters set in rotation.
10 To return to the “OFF” status keep the “STOP” button pressed for 4 seconds.
To Next Page
Loading...
