Smeg CMS4601NR - Page 18

18
EN
PROBLEM POSSIBLE CAUSE REMEDY
The milk does not come out of the milk
spout (C5).
The intake tube is not inserted or is inser-
ted incorrectly.
Insert the intake tube (C4) in the rubber
washer in the milk container lid (g. 24).
The milk is not well frothed. The milk container lid is dirty.
The frothed milk regulator is not positio-
ned correctly.
Clean the milk container lid as described
in the section “Cleaning the milk contai-
ner”.
Adjust following the instructions in the
section “Making cappuccino”.
The milk contains bubbles or squirts out
of the milk spout.
The milk is not cold enough or is not
semi-skimmed.
The frothed milk regulator is incorrectly
adjusted.
The milk container lid is dirty.
You should ideally use skimmed or
semi-skimmed milk at refrigerator tem-
perature (about 5°C). If the result is still
disappointing, try another brand of milk.
Move the frothed milk regulator slightly
towards the word “CAFFELATTE” (see sec-
tion “Making cappuccino”).
Clean the milk container lid as described
in the section “Cleaning the milk contai-
ner”.