User instructions
69
If an alarm occurs the appliance interrupts the program in progress and
signals a fault.
x Alarms E3, E4 and E9 interrupt the current program immediately.
x The E5, E6 alarms interrupts the running program once the cause is
resolved, it will bring bach the execution of the program.
x The alarm E7 is visualized at the end of the cycle that comes, however,
brought to the end since the operation of the dishwasher is not harmed.
To “reset” an alarm is necessary:
x Open and close the door, or turn off and on the machine. At this point is
possible to program the dishwasher again.
If the malfunction persists, contact your authorised Service Centre.
TECHNICAL DATA
Width
559 mm
Depth measured flush with the
outer edge of the control panel
550 mm
Height
578 mm
Capacity
7 Standard place settings
Water supply pressure
min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar)
Electrical characteristics
See rating plate
To Next Page
Loading...
