14
7. ELECTRONIC PROGRAMMER
FUNCTION KEY LIST
TIMER BUTTON
TIMED COOKING AND
SCHEDULED COOKING
BUTTON
CLOCK ADJUSTMENT AND
RESET
VALUE DECREASE BUTTON
VALUE INCREASE BUTTON
THE ELECTRONIC PROGRAMMER ONLY CONTROLS THE LARGE OVEN
AND HAS NO CONTROL OVER THE SMALL OVEN
At the end of each completed programming operation, 10 beeps will sound 3
times at intervals of about 1 minute. This sequence can be stopped at any time
by pressing any key.
7.1 Setting the time
When the oven is used for the first time, or after an interruption in the electricity
supply, the display flashes at regular intervals.
To set the time proceed as follows:
• Press to stop the display flashing;
• Press and hold for 2 seconds. A flashing dot will be seen between 2 and
3. The time can now be set;
• Press the value modification buttons or to increase or decrease the
setting by one minute for each pressure until reaching the desired time;
• Press or wait 5 seconds to exit the time setting mode.
To Next Page
Loading...
Need help?
General
