30
11.EXTRAORDINARY MAINTENANCE
The oven may require extraordinary maintenance or replacement of parts
subject to wear such as gaskets, bulbs, etc. The following instructions describe
how to carry out these minor maintenance operations.
Before any intervention that requires access to live parts, disconnect the
appliance from the power supply.
If a problem cannot be resolved through ordinary maintenance or in the case of
other types of fault, contact your local technical support centre.
11.1 Replacing the light bulb
If a light bulb needs to be replaced because it is worn or burnt out, proceed as
follows:
• Remove the guide frames, see “10.6
Removing guide frames”.
• Remove the bulb cover using a tool
(e.g. a screwdriver);
• Remove the bulb by unscrewing it as
shown;
• Replace the bulb with one of the same
type (25W - T300°C);
• Reassemble the cover being careful
that the moulded part of the glass is
facing the base of the bulb;
• Press the cover down as far as it will
go so that it attaches completely to the
bulb support.
To Next Page
Loading...
Need help?
General
