User instructions
14
3.3 Washing programs
The dishwasher is equipped with a control panel and an
DISPLAY from which it is possible to carry out all the power switch-on,
switch-off and programming operations.
Before starting a washing program make sure that:
• The water supply tap is open.
• The correct amount of detergent has been added to the
dispenser.
• The baskets have been correctly loaded.
• The spray arms are able to rotate freely and without
obstruction.
• The dishwasher door is securely closed.
Warning:
during the initial phase of the washing program, the operation of
sprayers is not perceived because they start rotating about 5 minutes
after the start. This is the normal operation of the washing cycle.
Pressing the ON/OFF button will start the dishwasher and will lit up the
dishwasher pilot light. After approximately 3 second from this operation
the DISPLAY will be turned on with a visualization that will depend upon
the state of the dishwasher.
All the programming operations are possible only with closed door. With
open door, on the DISPLAY will appear - - : - -.
To Next Page
Loading...
Need help?
General
