Instructions for the user
38
PROBLEM POSSIBLE CAUSE PROBABLE SOLUTION
Condensation forming on the gasket
of the freezer compartment door
(FAB28) or on the wall of the freezer
compartment next to the door
- The gasket is not providing an
airtight seal on the freezer
compartment.
- Adjust the hinge if necessary:
undo the two screws and raise or
lower the hinge slightly as
required. Then tighten the screws
to fix it in place. If the
condensation is on the top, raise
the hinge; if it is on the bottom,
lower it.
- open the door less often and for
shorter times, especially in warm,
humid weather conditions;
AFTER-SALES SERVICE – READING THE NAMEPLATE.
IF THE PROBLEMS WITH THE PRODUCT YOU HAVE PURCHASED ARE NOT AMONGST THOSE
DESCRIBED ABOVE AND IF YOU NEED MORE INFORMATION, PLEASE CONTACT THE AUTHORISED
AFTER-SALES SERVICE. YOU WILL FIND THE ADDRESS AND TELEPHONE IN YOUR LOCAL TELEPHONE
DIRECTOR UNDER SMEG.
TO SPEED UP THE SERVICE, PLEASE BE READY TO INFORM OUR CALL SERVICE OPERATORS OF THE
MODEL OF THE PRODUCT YOU HAVE PURCHASED AND THE SERIAL NUMBER MARKED ON THE
NAMEPLATE INSIDE THE BODY OF THE REFRIGERATOR. THANK YOU IN ADVANCE FOR YOUR
ASSISTANCE.
To Previous Page
Loading...
