1
SERIE GW0160 - GW2145 - GW1160 - GW4060 - GW4190
SERIE PW4060
SERIE WD2145 - WD1160 - WD4060 - WD4190
- TECHNICAL MANUAL -
19 490 0015 06 – EN 13/06/2016 Heading, new models: GW0160, PW4060
Manual Ed. Date Rev. Note
1 INTRODUCTION
This document is a compendium intended for the use of authorised engineers.
It must be used:
1. By the engineers who have been specifically trained by the manufacturer to perform maintenance work on the product
2. In association with the device’s user manual
3. In association with the latest-version electrical and functional diagrams.
Although this is not always necessary, it should be remembered that the “Tracelog” software made available by the manufacturer
allows communication with the instrument/glassware washers covered and is a useful troubleshooting aid for technical staff.
For details of spare parts and the latest-version documentation, please visit www.smegtech.com.
The diagrams shown can also be downloaded in pdf format from the www.smegtech.com website.
N.B.:
The diagrams shown below refer to the GW4060 and WD4060 models.
For complete technical documentation for all the models in the range, visit www.smegtech.com
The training of technical staff, provided by the main Customer Care service, is essential for the correct maintenance or repair of
devices.
2 START-UP
The user is responsible for preparing the utility systems required to allow the device to be connected and supplied correctly and
for positioning the device.
Refer to the user manual and the “INSTALLATION REQUIREMENTS” document.
The authorised engineer puts the device into service, checking:
1. that it has been installed correctly:
a. plumbing hookup;
b. electrical hookup;
c. that it is positioned in accordance with the relative requirements;
To Next Page
Need help?
General
