30
Press and hold the On/O button for 2 seconds to turn the hob on and activate
its functions. All the Digits show . and the Timer digits show “ C L “.
At this point the hob is on but all the cooking areas and the hood are at zero power.
The Hob will switch o automatically after 20 seconds if it is not used.
Warning: For safety reasons the hob can always be turned o using the On/O
button.
Warning: The functions that can be selected will always be the ones that are
illuminated/visible on the control panel, and these will always be the only ones that
can be activated.
Instructions for the installer: Check the hob power setting and change it if
necessary. See the paragraph “ Installer Menu (Hob power settings) “.
The hob is pre-set as standard to an absorption level of 7.4 Kw.
7. CONTROLS
To Next Page
Loading...
