Why is my Smeg PUM60X Ventilation Hood not sucking up smoke effectively?
There could be a couple of reasons why your Smeg Ventilation Hood isn't providing sufficient suction. First, the distance between the hood and the cooker might be too high; ensure it's between 650mm and 700mm. Second, the filters might be saturated; clean the grease filters regularly and replace the charcoal filters every 6 months.
What to do if the light and motor of my Smeg Ventilation Hood don't work?
If both the light and the motor of your Smeg Ventilation Hood aren't working, the most likely cause is a lack of power supply. To check this, plug another appliance into the same socket to confirm that there is power.
How to fix a Smeg PUM60X Ventilation Hood when the light is on but the motor isn't working?
If the light on your Smeg Ventilation Hood is on, but the motor isn't working, it could be due to several reasons. One potential cause is a blocked outlet valve; detach the flue and duct, then turn on the hood to see if the valve opens. Other possible causes could be a failed capacitor or a failed control switch.
Why is my Smeg PUM60X vibrating?
If your Smeg Ventilation Hood is vibrating, it could be due to a damaged or unbalanced propeller, or it might not be installed correctly. Review the installation instructions and check the installation again for any loose screws, brackets, or connections.
Ensure permanent and adequate room ventilation when using hood with gas or other fuel appliances.
Wait 30 minutes after switching off before checking filters to avoid scalding.
Avoid touching the light within 30 minutes of appliance use due to heat.
Do not operate gas cooker without a pan; it's a fire hazard and can damage hood.
Always disconnect the electrical plug before performing any maintenance.
Appliance is not for unsupervised use by children; ensure a responsible person supervises safe usage.
Confirm the power is switched off before commencing any cleaning.
Never cook with an open flame directly under the range hood.
Technical issues should only be handled by a suitably qualified person for repairs or inspection.
Control fan speed (Low, Mid, High) using the speed adjustment buttons.
Press the Stop button to turn off the motor.
Press the Low button to activate the motor at its lowest speed setting.
General| Type | Wall-mounted |
|---|---|
| Width | 60 cm |
| Number of Speeds | 3 |
| Lighting | LED |
| Noise Level | 62 dB |
| Filter Type | Aluminium |
| Installation | Wall-mounted |
| Number of Lights | 2 |
| Material | Stainless Steel |
| Number of motors | 1 |
To Next Page
