EN 9
In the case of the disc lter, simply tilt the two lters by
90° as shown in (g.A) and then extract them from their
housing.
In the case of a cartridge lter attached with springs, (g.B)
exert the pressure required to counteract the resistance of
the spring and then remove the lter
In the case of a cartridge lter blocked with a bracket and
threaded knob, (g. C), unscrew the knob, remove the locking
bracket and then remove the active carbon lter. Replace the
carbon lters and the metal non-grease lters by performing
the operations in inverse order
Before performing any maintenance and/or cleaning always disconnect the
hood from the power supply
Depending on the model, the hood can be equipped
with different types of lighting, with LED or halogen
lamps:
a) WITH LED LIGHTS: The LED lights guarantee a
signicant number of hours of operation. Should it be
replace due to being worn or faulty, the entire spotlight
must be replaced. In this case, contact qualied
Technical Support. This appliance is equipped with
Class 1M white LED light, in accordance with EN
standard 60825-1: 1994 + A1:2002 + A2:2001;
maximum emitted optical power@439nm: 7μW.
Do not look directly at the light with optical instruments
(binoculars, magnifying glass...).
b) Halogen: lamp with G4 tting, 20W power and 12V
voltage. Replace the lamp by removing the glass
support ring of the spotlight with a screwdriver. Once
the glass is removed, remove the faulty lamp from
its housing and t the new lamp. Replace the glass
of the spotlight by blocking it with the ring.
Code ILCOS: HSG/C/UB-20-12-G4
REPLACEMENT LAMPS:
To Next Page
Loading...
