What to do if my Smeg Washer doesn't start?
If your Smeg Washer isn't starting, make sure the plug is properly connected to the socket, the door is securely closed, and the “Start/Pause” button has been pressed.
What to do if my Smeg LST127-2 does not spin?
If your Smeg Washer does not spin and the laundry is still wet at the end of the cycle, the anti-imbalance safety device may have tripped because the laundry is not evenly distributed in the drum. Rearrange the laundry in the drum by hand and repeat the spin programme only.
How to fix strong vibrations during spins of Smeg LST127-2 Washer?
If your Smeg Washer is vibrating strongly during spins, ensure the appliance is properly leveled, it's not too close to walls or kitchen units, and the internal unit on flexible mounts is locked in position.
What to do if Smeg Washer is not pumping out water?
If your Smeg Washer isn't pumping out water, check that the drain hose is not kinked and the drain pump is not fouled.
Why is laundry not properly spun in Smeg LST127-2 Washer?
If laundry is not properly spun in your Smeg Washer, it may be because large items are screwed up and not evenly distributed within the drum. Always wash a mix of large and small items.
Why is there water on the floor near my Smeg LST127-2?
If you find water on the floor near your Smeg Washer, check that the water intake hose fittings are not loose and the end of the drain hose is correctly positioned.
Why is my Smeg LST127-2 not filling with water?
If your Smeg Washer is not filling with water, check that the plug is properly connected to the socket, the door is securely closed, the water tap is turned on, the water intake hose filters are not fouled, and the water intake hose is not trapped or kinked.
Why is there too much foam in my Smeg Washer?
If too much foam forms in the tank and flows out of the drawer of your Smeg Washer, verify that the detergent used is recommended for automatic washing machines (and not for hand washing) and that the quantity used is as stated in the manual and no more.
Why are there traces of detergent on laundry from Smeg Washer?
If you notice traces of detergent on laundry washed in your Smeg Washer, it may be because many phosphate-free detergents contain substances with low water solubility. Select the Rinse programme or brush the laundry.
What to do if washing results are unsatisfactory with Smeg LST127-2 Washer?
Washing results may be unsatisfactory if too little or an unsuitable detergent was used, difficult stains were not dealt with before washing, the correct temperature was not set, or the basket was overloaded.
General| Built-in display | Yes |
|---|---|
| Inlet hose length | 1.5 m |
| Cold water fill | Yes |
| Rinse Plus function | Yes |
| Maximum spin speed | 1200 RPM |
| Spin-drying class | B |
| Rated capacity | 7 kg |
| Washing class | A |
| Delayed start timer | Yes |
| Delay start (max) | 24 h |
| Remaining time indication | Yes |
| Child lock | Yes |
| Power consumption (off) | 0.5 W |
| Current | 10 A |
| Width | 596 mm |
| Depth | 54 cm |
To Next Page
