Instructions
6
zones.
• Do not use harsh abrasive
cleaners or sharp metal scrapers
to clean glass since they can
scratch the surface, which may
result in shattering of the glass.
• Do not use cleaning products
containing chlorine, ammonia or
bleach on parts made of steel or
that have metallic surface finishes
(e.g. anodizing, nickel- or
chromium-plating).
• Do not wash the removable
components such as the hob grids,
flame-spreader crowns and
burner caps in a dishwasher.
Installation
• NOT SUITABLE FOR USE WITH
AFTERMARKET LIDS OR
COVERS.
• This appliance must not be
installed in a boat or caravan.
• This appliance must not be
installed on a pedestal.
• If the electrical supply is restricted,
means of all-pole disconnection
must be accessible and
incorporated in the fixed wiring in
accordance with the wiring rules
• Position the appliance into the
cabinet cut-out with the help of a
second person.
• To prevent any possible
overheating, the appliance should
not be installed behind a
decoration door or a panel.
• Before any operation on the
appliance (installation,
maintenance, positioning or
movement) always wear PPM.
• Before performing any operation
on the appliance, switch off the
power supply.
• Have qualified personnel carry
out installation and assistance
interventions according to the
standards in force.
• Means of disconnection of
appliance must be incorporated in
the fixed wiring in accordance
with the wiring rules.
• Have the gas connection
performed by authorised staff.
Installation with a hose must be
carried out so that the length of the
piping does not exceed 2 metres
when fully extended (for steel
hoses).
• The hoses should not come into
contact with moving parts and
should not be crushed in any way.
• If required, use a pressure
regulator that complies with
current regulations.
• After carrying out any operation,
check that the tightening torque of
gas connections is between
10 Nm and 15 Nm.
• At the end of the installation,
check for any leaks with a soapy
To Next Page
Loading...
