Smeg SA711XA - User Manual

SA711XA
smeg 70cm highlight ceramic cooktop, touch control
ID180609
Code SA711XA
size 700mmW x 520mmD x 55mmH
cutout 660mmW x 490mmD
finish black ceramic frameless surface
edge bevelled ceramic
zones four plus two expansion zones
controls touch
heat levels nine per zone
timer 1–99 minutes programmable
cooking times, simultaneous and
variable times, audible signal
residual heat hot surface ‘H’ LED warning
elements all high-speed series 8 ribbon
elements, full heat 7 seconds
warranty in-house, two years parts and
labour
kitchen timer INDEPENDENT 1-99 minute timer
with audible signal
PLEASE NOTE: smeg ceramic cooktops are highly-efficient
cooking surfaces. They are at their most efficient with flat-
based cooking vessels. We recommend stainless steel exterior
based vessels — that is, the surface be of stainless steel. This
flat stainless steel surface will help preserve the unblemished
look of the ceramic surface and help avoid scratching and
permanent marking. High-quality cast-iron surfaces may also
be suitable.
“GO AND STOP”
For improved energy and time efficiencies, when a heat setting is
selected for a particular zone, full power is applied for a very brief initial
phase before it returns to the preselected heat level. This pre-emptive
heat aid is referred to as ‘go and stop’ in the cooktop’s accompanying
instruction booklet.
AUTOMATIC STOP
Each zone can be preset with an individual cooking duration (up
to 99 minutes). This timed cooking can be selected for respective
different times on different zones — that is, all zones can be operated
simultaneously and at different time settings. When the individual zone’s
timed cooking duration elapses, the controls will flash ‘00’ and an
audible signal will emit.
KITCHEN TIMER
The cooktop’s controls can also be used as an independent, variable
countdown timer with audible end signal. Range is one through 99
minutes.
THERMAL OVERLOAD PROTECTION
For safety, the cooktop will default to ‘OFF’ in any extreme conditions,
such as a continuous overflow of boiling fluids or a utensil cooking its
contents dry. Cooking can only be resumed after the fault has been
cleared from the electronic LED safeguards. Also for safety reasons,
cooking cannot resume automatically — it must be manually restarted.
WARNING: technical specifications and product sizes can be varied by the manufacturer,
without notice. Cutouts for appliances should only be by physical product measurements.
The above information is indicative only.

Summary

Smeg Cooktop Features and Operation

Go and Stop Function

Enhances energy and time efficiency by providing a brief full power boost before settling to the preselected heat level.

Automatic Stop Functionality

Allows presetting individual cooking durations (up to 99 mins) for each zone, with audible signal upon completion.

Kitchen Timer

Independent, variable countdown timer with an audible signal, ranging from 1 to 99 minutes.

Thermal Overload Protection

Safety feature that defaults the cooktop to 'OFF' in extreme conditions, requiring manual restart after fault clearance.

Cooktop Dimensions and Specifications

Zone Specifications

Details the diameters and wattages for each cooking zone (A, B, C) on the ceramic cooktop.

Overall Dimensions and Cutout

Provides front, side, and cutout dimensions for installation, including bevelled edge detail.

Weight and Volume

Specifies packaged dimensions, gross weight, and net weight of the cooktop.

Smeg SA711XA Specifications

General

Type	Gas
Number of Burners	5
Material	Stainless Steel
Gas Type	Natural Gas / LPG
Safety Features	Flame Failure Device
Control setting position	Front
Aesthetics	Stainless steel
Burner Types	1 x Rapid, 2 x Semi-Rapid, 1 x Auxiliary
Ignition	Automatic Electric Ignition