User instructions
12
Only at the end of the Eco program will Enersave be activated, which
further reduce energy consumption. At the end of the washing, an
automatic device releases the door, which opens slowly a few inches. This
allows optimal drying, even at low rinsing temperatures, allowing
significant energy savings. Once the door has opened, the end of the wash
cycle is indicated by a short beep.
Do not leave anything in the space in front of the door necessary to allow
it to open.
Do not re-close the door during automatic opening as this would
damage the mechanism. Wait for the pushers to retract before re-closing
the door.
run the soak program with half loads.
Options cannot be used with the soak program.
* Standard programme under
.
** See information sheet provided
**** Reference program for laboratories: Detergent:
in the
+
in
the door or tablet. Configuration: see photo in “Using the baskets”.
(1) Program consumption and duration figures have been measured in accordance
with the EN 50242 standard. Values may vary depending on intake water and
room temperatures and the type and quantity of dishes loaded.
(2) 1 or 2 cold rinses depending on the model.
REFERENCES for the ENERGY LABEL supplied with the dishwasher:
- Annual energy consumption is based on 280 standard wash cycles with cold
water and consumption of low-energy operating modes. Actual consumption
depends on the way in which the appliance is used.
- Water consumption is based on 280 standard wash cycles. Actual
consumption depends on the way in which the appliance is used.
- Information refers to the EN 50242 STANDARD programme (identified in the
programmes table), which is the most effective in terms of combined energy
and water consumption. The programme is recommended for dishes with a
normal level of dirt.
- Drying efficiency class on a scale from “G” (minimum efficiency) to “A”
(maximum efficiency).
To Next Page
Loading...
