Electrical and Water connection
A Schuko 16 A socket with an efcient grounding should be made
available for the electrical mains connection, as well as an omnipolar
switch which can easily be reached when the appliance is installed.
To connect to the water supply system (for appliances equipped with
ice makers) a tap with a male 3/4” connection should be provided,
which must also be easily accessible once the appliance is installed.
The appliance is provided with a water supply hose and seal kit which
is suitable for high water pressure and complies the Food Regulations.
The water lter cartridge, which is provided with the appliance, should
be installed according to the accompanying instructions.
Use only the new hose and the new gaskets which are supplied with
the appliance. Discard any hose and gasket which may have already
been installed.
Electrical cord length: 2,0 mt (78 3/4”)
Water connection line length: 2,5 mt (98 3/8”)
Series: All
Do not use extension cords or adapters.
Once the appliance has been connected to
the water system, turn the Ice Maker off (touch
the button
on control panel to switch it off)
before the main water is shut off.
The appliance should be connected only to
a drinkable water supply system.
The Built-in lter cannot make it safe to drink
any water which is not suitable for human
consumption.
Energy: Alternatives and Home Automation
If energy is supplied through an alternative energy power source
(solar, geothermal, etc..) or if home automation systems are installed,
it is necessary to install the Alternative Energy Kit to integrate the unit
into the power grid.
Electrical and water supply behind the unit
Integrated and Classic Series StandPlus and Free-Standing Series
To Next Page
Loading...
