Instructions
41
EN
• Do not modify this appliance.
• Do not insert pointed metal
objects (cutlery or utensils) into the
slots in the appliance.
• Do not use aerosols in the vicinity
of this appliance whilst it is in use
• Do not use aerosols in the vicinity
of this appliance whilst it is in use
• This appliance must not be
installed in a boat or caravan.
• Before any operation on the
appliance (installation,
maintenance, positioning or
movement) always wear PPM.
• If required, use a pressure
regulator that complies with
current regulations.
• Installation using a hose must be
carried out so that the length of
the hose does not exceed
2 metres when fully extended for
steel hoses and 1.5 metres for
rubber hoses.
• The hoses should not come into
contact with moving parts and
should not be crushed in any way.
• At the end of the installation,
check for any leaks with a soapy
solution, never with a flame.
• The appliance must be connected
to ground in compliance with
electrical system safety standards.
• Do not try to repair the appliance
yourself or without the intervention
of a qualified technician.
• Do not pull the cable to remove
the plug.
• Use cables withstanding a
temperature of at least 90°C.
• If the power supply cable is
damaged, contact technical
support immediately and they will
replace it.
• The tightening torque of the
screws of the terminal board leads
must be 1.5 - 2 Nm.
• After carrying out any operation,
check that the tightening torque of
gas connections is between
10 Nm and 15 Nm.
• Position the appliance into the
cabinet cut-out with the help of a
second person.
To Next Page
Loading...
