Smeg S7212LS2P - Door Reversibility

5 cm
min.
200 cm
2
min.
200 cm
2
CAUTION! Refer to the
assembly instructions for the
installation.
Door reversibility
The door of the appliance opens to the
right. If you want to open the door to the
left, follow these steps before you install the
appliance:
1.
Loosen and remove the upper pin.
2. Remove the door.
3. Remove the spacer.
4. With a key, loosen the lower pin.
5. Tighten the lower pin on the opposite
side.
6.
Install the spacer.
7.
Install the door.
8.
Tighten the upper pin.
Installing the appliance
CAUTION! Make sure that the
mains cable can move freely.
1.
If necessary cut the adhesive sealing
strip and then apply it to the appliance
as shown in figure.
x
x
2. Install the appliance in the niche.
3. Push the appliance in the direction of
the arrows (1) until the upper gap cover
stops against the kitchen furniture.
25