Problem Possible cause Solution
The temperature in the ap-
pliance is too high.
Contact a qualified electrician
or contact the nearest Author-
ised Service Centre.
The compressor operates
continually.
Temperature is set incor-
rectly.
Refer to "Operation" chapter.
Many food products were
put in at the same time.
Wait some hours and then
check the temperature again.
The room temperature is
too high.
Refer to climate class chart on
the rating plate.
Food products placed in
the appliance were too
warm.
Allow food products to cool to
room temperature before stor-
ing.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The FastFreeze function is
switched on.
Refer to "FastFreeze function".
There is too much frost and
ice.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
Refer to "Closing the door".
The compressor does not
start immediately after press-
ing the FastFreeze, or after
changing the temperature.
This is normal, no error has
occurred.
The compressor starts after a
period of time.
Water flows on the floor. The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
Attach the melting water outlet
to the evaporative tray.
Temperature cannot be set. The FastFreeze or Intensi-
veCooling function is
switched on.
Switch off FastFreeze or Inten-
siveCooling manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FastFreeze or In-
tensiveCooling function".
DEMO appears on the dis-
play.
The appliance is in demon-
stration mode.
Keep the Mode pressed for ap-
proximately 10 seconds until a
long sound is heard and display
shuts off for a short time.
The temperature in the appli-
ance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower temperature.
26
To Next Page
Loading...
