Why my Smeg SLB600 tub does not fill with water?
If the tub of your Smeg Washer isn't filling with water, check that the plug is correctly fitted into the socket and the door is securely closed. Also, ensure the water tap is open and the water inlet filters are not clogged.
What to do if water does not drain from Smeg SLB600?
If the water isn't draining from your Smeg Washer, check that the drain hose is not twisted and the drain pump is not clogged.
Why Smeg SLB600 is not spinning?
If your Smeg Washer isn't spinning, the unbalanced load sensor may have been triggered because the washing is not uniformly distributed inside the drum. If the washing is wet at the end of the cycle, distribute it well inside the basket and repeat just the spin cycle.
What to do if Smeg SLB600 washing has not been correctly spun?
If the washing in your Smeg Washer hasn't been correctly spun, it might be because large items have rolled up and are not uniformly distributed inside the drum. Always wash large items together with small ones.
How to remove detergent residues on washing from Smeg SLB600?
If there are residues of detergent on the washing after using your Smeg Washer, it may be because many phosphate-free detergents contain substances that are difficult to dissolve in water. Select the Rinse programme or brush the washing.
How to fix Smeg Washer that does not start?
If your Smeg Washer isn't starting, make sure the plug is correctly fitted into the socket, the door is securely closed, and the “Start-Pause” button has been pressed.
What to do if a leak has occurred and aquastop has triggered in Smeg SLB600 Washer?
For this type of error, turn off the water tap, remove the plug and contact the Service Centre.
Guidance on correctly positioning and levelling the washing machine.
Instructions for connecting the washing machine to the water supply.
How to properly connect the drain hose.
Detailed steps for safely connecting the washing machine to the electrical power supply.
How to correctly use detergent and fabric softener.
Checks to perform if the washing machine fails to start.
Troubleshooting steps for when the tub does not fill with water.
Steps to resolve issues where the machine is not draining water.
Identifying potential causes for water leaks onto the floor.
Interpreting error codes indicated by flashing LEDs.
To Next Page
General
