Smeg ST8646U - Adjusting the upper rack

EN
28 Rev. 0.1
Adjusting the upper rack
The upper rack can be set in three different positions on both sides. The rack
must be level on both sides.
To raise the rack (ref. A fi g. 4-15), lift it with the two handles (e.g.: ref. B fi g.
4-15) to the fi rst or second catch depending on the height required. To lower it
(ref. c fi g. 4-15), pull up the two release levers (e.g.: ref. D fi g. 4-15). This is also
possible with the rack loaded, but in this case when lowering the rack it should
be held steady with one hand to avoid knocking the dishes.
A
B
D
C
Fig. 4-15
USER INSTRUCTIONS