8.1 What to do if...
Problem Possible cause Solution
The appliance does not operate. The appliance is switched off. Switch on the appliance.
The mains plug is not connected
to the mains socket correctly.
Connect the mains plug to the
mains socket correctly.
There is no voltage in the mains
socket.
Connect a different electrical ap‐
pliance to the mains socket. Con‐
tact a qualified electrician.
The appliance is noisy. The appliance is not supported
properly.
Check if the appliance stands
stable.
Acoustic or visual alarm is on. The cabinet has been recently
switched on.
Refer to "Door open alarm" or
"High temperature alarm".
The temperature in the appliance
is too high.
Refer to "Door open alarm" or
"High temperature alarm".
The door is left open. Close the door.
The compressor operates contin‐
ually.
Temperature is set incorrectly. Refer to "Control panel" chapter.
Many food products were put in
at the same time.
Wait a few hours and then check
the temperature again.
The room temperature is too
high.
Refer to "Installation" chapter.
Food products placed in the ap‐
pliance were too warm.
Allow food products to cool to
room temperature before storing.
The door is not closed correctly. Refer to "Closing the door" sec‐
tion.
The FastFreeze function is
switched on.
Refer to "FastFreeze function"
section.
The compressor does not start
immediately after pressing the
"FastFreeze", or after changing
the temperature.
The compressor starts after a pe‐
riod of time.
This is normal, no error has oc‐
curred.
Door is misaligned or interferes
with ventilation grill.
The appliance is not levelled. Refer to installation instructions.
Door does not open easily. You attempted to re-open the
door immediately after closing.
Wait a few seconds between
closing and re-opening of the
door.
The lamp does not work. The lamp is in stand-by mode. Close and open the door.
The lamp is defective. Contact the nearest Authorized
Service Centre.
ENGLISH 35
To Next Page
Loading...
