Why does my Smeg WMI14C7-2 not spin?
If your Smeg Washer isn't spinning and the laundry is still wet at the end of the cycle, it may be due to the anti-imbalance safety device being tripped. This happens when the laundry is not evenly distributed in the drum. To resolve this, rearrange the laundry in the drum by hand and repeat the spin programme only.
How to troubleshoot a Smeg Washer that doesn't start?
If your Smeg Washer isn't starting, make sure the plug is correctly inserted into the socket, the door is completely closed, and the “Start/Pause” button has been pressed.
What to do if my Smeg Washer is not filling with water?
If your Smeg Washer isn't filling with water, verify that the plug is properly connected to the socket, the door is securely closed, and the water tap is turned on. Also, check that the water intake hose filters aren't blocked and the hose isn't trapped or kinked.
Why is water not pumping out of my Smeg WMI14C7-2 Washer?
If your Smeg Washer is not pumping out water, check to ensure that the drain hose is not kinked and the drain pump is not blocked.
How to reduce strong vibrations during spins of my Smeg WMI14C7-2?
To reduce strong vibrations during spins with your Smeg Washer, ensure the appliance is properly leveled, not too close to walls or kitchen units, and the internal unit on flexible mounts is locked in position.
What to do if there's water on the floor around my Smeg WMI14C7-2 Washer?
If you find water on the floor around your Smeg Washer, check that the water intake hose fittings are not loose and the end of the drain hose is correctly positioned.
Why is there too much foam in my Smeg WMI14C7-2 tank?
If there's excessive foam in your Smeg Washer tank flowing out of the drawer, make sure you're using a detergent recommended for automatic washing machines and not for hand washing. Also, ensure you're using the correct quantity of detergent as stated in the manual.
Why are the washing results from my Smeg Washer unsatisfactory?
Unsatisfactory washing results from your Smeg Washer could be due to using too little or an unsuitable detergent, or because difficult stains were not pre-treated before washing. It could also be because the correct temperature wasn't set, or the basket was overloaded.
Why is my laundry not properly spun in my Smeg WMI14C7-2?
If your laundry is not properly spun in your Smeg Washer, it could be because large items are screwed up and not evenly distributed within the drum. Always wash a mix of large and small items to prevent this.
Why is fabric conditioner not fully used in my Smeg WMI14C7-2?
If fabric conditioner is not fully used or there's too much water left in the compartment of your Smeg Washer, check that the detergent drawer siphons are correctly fitted and not blocked.
To Next Page
General
