smithandnoble.com 800.248.8888
2
HOW TO OPERATE YOUR MOTORIZED SHADES
Operate Your Shade with a Motivia Wand
Press the DOWN or UP button to lower or raise the shade.
Press the STOP/FAVORITE to stop the shade at the desired position.
To fully raise or lower the shade, simply press the UP or DOWN button and then
release. The shade will automatically stop when it reaches the upper or lower limit.
(If the upper or lower limits are not set at the desired positions, see the
Adjust Motor Limits section below)
Note: Upper and lower limits stops are set at the factory. An intermediate, or “favorite”
position is not set at the factory. See page 3 for more information.
Adjust Motor Limits (if desired)
The Upper and Lower Limits have been set at the factory. If you need
to make adjustments to the limits, follow the instructions below.
Press the Settings button on the back of the wand and hold it in until the
motor stops beeping. This will clear both the upper and lower factory limits.
• SET UPPER LIMIT - Press the Up button to get the shade close to the
upper limit and then press the Stop button to stop the shade.
Tap the Up or Down button to move the shade to the desired position.
To save the location, press the Settings button until the motor beeps.
• SET LOWER LIMIT - Press the Down button to get the shade close to
the lower limit and then press the Stop button to stop the shade.
Tap the Up or Down button to move the shade to the desired position.
To save the location, press the Settings button until the motor beeps.
Setting
Button
Up
Down
Stop/Favorite
Up
Down
Stop/Favorite
To Next Page
Loading...