smithandnoble.com 800.248.8888
5
If all else fails, simply REBOOT and RELINK to begin the entire programming process over.
REBOOT and RELINK is also known as, When in Doubt, Clear it Out.
• STEP 1: Hold the red Setting* button down for 10 seconds. The motor will jog during this time and
sound like (jog, jog/jog). (Shade shifting up and down) After a single set of jogs, release the red button.
If programming more than one shade, then unplug the battery pack of the other shades.
• STEP 2: Select the desired channel on the remote.
• STEP 3: Hold the red Setting* button down again. However, this time hold it ONLY
long enough so that the shade jogs ONCE. Release the button as soon as it jogs.
• STEP 4: Flip the remote over to reveal the two buttons, C-Conrm and L-Limit.
• STEP 5: Press and hold the Conrm button (left side button) until the shade jogs.
Note: If the shade does not respond, repeat Step 2 above to link shade to remote.
• STEP 6: Press and hold the Limit button (right side button) until the shade jogs.
• STEP 7: Push and release the Up or Down button to move the shade to the
desired upper or lower limits.
• STEP 8: When the shade nears your desired upper or lower limits, press the Stop button.
• STEP 9: Press the Up or Down buttons to adjust your shade to the precisely desired
upper or lower limit. The shade will jog one step each time you press Up or Down
• STEP 10: When the shade has reached the desired location, press and hold the Conrm
button until the shade jogs. Your limit is now set.
• STEP 11: Repeat steps 7 – 10 to set your opposite (either upper or lower) limit.
• STEP 12: Run the shade up and down to be sure the limits are set correctly.
RESET AND REPROGRAM THE SHADE - REMOTE CONTROL
WHAT IS JOGGING? Jogging refers to the shade shifting up and down.
*
Setting button is located on the underside of the motor on the shade. (see illustration)
P
Press both buttons
simultaneously to
lock in upper and
lower limits
Setting*
(Red button)
SN2025 SN_IL_MG_2016_1
To Previous Page
Loading...