7
Introduction
Before using your Stand Mixer for the first time
Read all safety instructions in this manual before operating. Before using this appliance for
the first time, follow the steps below:
• Place the Stand Mixer on a flat, level, heat resistant surface.
• Wash all accessories in warm soapy water and dry thoroughly.
• With the exception of the stainless steel whisk and bowl, all accessories are NOT
dishwasher safe.
Speed Knob - Speed Regulating & Pulse Speed
• To adjust the speed, use the speed control knob as below:
Always start mixing on level 1 and slowly increase the speed to level 6 as the
ingredients start to combine.
• Adjust the speed control knob clockwise or anti-clockwise depending on the speed you
require.
• To use the pulse switch:
Turn and hold the control dial to ‘P’, the machine will move into the fastest speed.
Turn the control dial to ‘0’, the machine will stop moving.
Inserting the dough hook, flat beater and whisk
• Press the release button and gently lift the tilting arm upwards.
• Insert the mixing tool into the corresponding groove of the
socket of the tilting arm, push up and turn the tool to lock into
position.
• Press the release button and gently lower the tilting arm to its
lowered position.
! CAUTION: Remove the plug from the socket when you are
inserting the dough hook, beater or whisk.
Using the Stand Mixer
1. Press the release button and gently lift the tilting arm upwards.
2. Place the mixing bowl filled with ingredients onto the mixing stand and twist to lock in place.
3. Insert the mixing tool into the corresponding groove of the socket of the tilting arm, push
up and turn the tool to lock into position.
4. Place the pouring shield over the bowl.
5. Press the release button and gently lower the tilting arm to its lowered position.
To Next Page
