Smiths Level 1 DSTA-40 - Page 7

DSTA-40 TEMP CHECK Thermometer Operator’s Manual
Instructions For Use
Temperature Verification And Calibration
Step 1: Required Tools
TEMP CHECK
e Clear plastic tube
+ Clear plastic tube with white sleeve
e Gas Vent/Filter Assembly
#3 Phillips head screwdriver
3.175 mm (1/8 inch) flat head screwdriver
Step 2: Check the Ambient Temperature
1 Check the ambient room temperature.
2 Adjust the ambient room temperature to 22°C +2°C.
Note: The procedures in this manual are written to be accurate and will only be valid when calibration is
done in an ambient temperature of 22°C +2°C.
Note: TEMP CHECK Thermometers are designed for measuring recirculating solution only and are
NOT intended for measuring ambient temperatures.
Note: The TEMP CHECK and the H-1200 Fluid Warmer may not display the same temperature during
the warm up period. This is normal.
Step 3: Assemble the TEMP CHECK Thermometer
1 Insert the clear plastic tube into the bottom fitting on the TEMP CHECK. Press firmly in place until the
clear plastic tube meets the stop.
2 Insert the longer end of the plastic tube with white sleeve into the top of the TEMP CHECK. Press
firmly in place until the clear plastic meets the stop.