WWW.SMITTYBILT.COM
Installation Instructions
Scout Trailer Kit
Part#87400/87400-01
23. Install tongue box onto the tongue by lining up the mounting holes in the box with the holes on
the tongue. Use M10 bolts , flat washer, large washer, lock washer and nut to secure to tongue.
Make sure all bolts are in place before tightening hardware. Torque to 25 ft/lb. If not installing
tongue box, install tongue box bolts to the tongue as they help secure the tongue cover plate. Fig
22 shows tongue box mounted. Fig 23 shows bottom side of trailer tongue and the tongue box
hardware. While under the tongue check torque on the pre-installed parking brake lever.
Fig 22
Fig 23
24. Install break away brake system. First
mount the box mounting bracket to the
tongue. Use M6 hardware. It may be
easier to remove the tongue plate to
access the hardware, then re-install
tongue plate. Second, attach break away
box to the bracket. You will want to run
the wires thru the tongue plate before
bolting the box to the bracket. Wire the
brake away system into trailer wiring
according to the instructions that are
included with the break away system.
Use the supplied deutsch connector. Fig
24. Leave tether switch loose till step 30.
Fig 24
23
To Next Page
Loading...