1 – INTRODUCTION
HYDROVERT NXP is an inverter with built-in EMC filter in compliance with 2004/108/EC (Electromagnetic
Compatibility) and 2006/95/EC (Low Voltage) Directives, fitted with special software for hydraulic systems,
which can operate with both old and new control units.
It controls the UPWARD run phase and, with suitable hydraulic control unit, also the DOWNWARD run.
The following advantages are attained:
• No peak currents. The maximum start-up current is the nominal current.
• Possibility of setting a network maximum input power limit, to contain the contractual power.
• Reduction of consumptions.
• Optimisation of run comfort.
• Power factor correction of the network input power. Cos
0.98.
• Possibility of selecting the inspection speed value.
HYDROVERT NXP is available in various sizes, for motors with maximum input current up to 170A.
In the following A TABLE is given, which states indicative values, as an example, of POWER
CONSUMPTION and ENGAGED POWER that can be obtained with HYDROVERT NXP.
TABLE 1 – Power Consumption and Engaged Power
To Next Page
