1. Aach the massager to a chair with elasc straps or place it on other support.
2. Connect the adapter cable to the corresponding cable on the cushion.
3. Plug the home adapter into an outlet.
4. Turn on the device using the controller ( instrucons on page 5 ).
5. When finished place the controller in the pouch at the side of the cushion.
6. The detachable intensity control flap lets you choose a soer or more intense massage.
7. You also may soen the massage pressure by placing a blanket or towel between you
and the device.
• You should allow your body some rest periods. To avoid straining your muscles
too much, we recommend to Not exceed a connuous massage of 15 Minutes
per me and Not exceed 3 mes use one day.
• The device will automacally switch off aer 15 minutes mer run out.
• Remove the adapter from the outlet when not in use.
• Do not setup or use the massager in a bathroom or similary wet / damp areas.
Blanket
/Towel
① Install the flap onto the cushion to get a soer massage.
①
②
③
② Place a blanket or towel between you and the massager to achieve a far soer massage
intensity if you sll feel too strong shiatsu aer installing the flap onto the cushion.
③ If you want to massage your lower back, but the shiatsu nodes can not reach that low.
You may adjust the height of your back when sing, by placing a seat cushion or a pillow
on the sing part.
! Aenon
If the shiatsu can’t reach your lower back area
If the Shiatsu is too strong,
Seat cushion
3
Setup and Operaon
! Aenon
Removable
flap
To Next Page
