Snailax SL-482 - Instructions for Use; Replacing Massage Heads; Operating the Massager; Control Button Guide

3
Instrucons for use
Power Buon
Intensity Buon
Mode Buon
Heat Buon
1. Turn off the massager before replacing another massage head.
2. Your massager comes equipped with 4 aachments (Figure 1).
Aach the different heads by twisng clockwise (Figure 2), detach
the installed massage head by twisng an-clockwise and pulling
out (Figure 3). Always turn off the device while replacing the heads.
Fig.2
Fig.3
Press to choose High,
Medium,Low
intensity of vibraon
Press to change Mode
between M1 to M3
Press to turn the
Heat funcon
on or off
Press to turn the
massager on/off
NOTE: When Power
buon indicator turns
green and blink, that
means the baery is low,
please charge in me.
It is safe to use the
massager while charging.
3. Turn on the massager by operang the control buons
(insturcons as below)
4. Apply the massager head lightly to the area you wish to treat.
Move the unit slowly, holding it over the targeted area. Treat the
area for a short period of me and move to
another area. NEVER treat the same area for longer than 3 minutes.
5. To turn the unit off by pressing the power buon. For your safety
the device will automacally turn off aer 15 minutes of connuous
use.