Snap-On QE Series - USING TE SERIES TORQUE WRENCHES; TE Series Follow-up Needle Model Usage; TE Series Signal Model Usage

PROPER USE OF TE SERIES TORQUE WRENCHES
Fig. 5 - TE Series Torque Wrench
Follow-up Needle Model
1. Turn the dial until the main pointer is on zero. Then set the follow-up pointer on zero.
2. To torque fastener, keep hand centered on the handle, apply a slow steady force in the
desired direction (clockwise or counterclockwise).
3. When pressure is released, the main pointer will return to zero and the follow-up pointer
will remain at the torqued value
4. Each time the wrench is used, be sure that the dial and main pointer are set correctly.
Signal Model
Fig. 6 - TE Series Torque Wrench – Signal Model
1. Turn the dial until the pointer is on desired torque setting.
2. Torque fastener (see step 2 above).
3. When torque setting is achieved, light and beep will turn on. Stop pulling.
CONVERSION TABLE
To Convert
From To
Multiply
By
To Convert
From To
Multiply
By
Ib. in. oz. in. 16 oz. in. Ib. in. .0625
Ib. in. Ib. ft. .08333 Ib. ft. Ib. in. 12
Ib. in. kg.cm. 1.1519 kg.cm. Ib. in. .8681
Ib. in. kg.m. .011519 kg.m. Ib. in. 86.81
Ib. in. Nm. .113 Nm. Ib. in. 8.85
Ib. in. dNm. 1.13 dNm. Ib. in. .885
Ib. ft. kg.m. .1382 kg.m. Ib. ft. 7.236
Ib. ft. Nm. 1.356 Nm. Ib. ft. .7376
Nm. dNm. 10 dNm. Nm. .10
Nm. kg.cm. 10.2 kg.cm. Nm. .09807
Nm. kg.m. .102 kg.m. Nm. 9.807
Follow-up Pointer
Main Pointer
Dial
Follow-up Pointer
Main Pointer
Dial
Light
Beeper
3