Snap-On Thermal Laser Quick Start Guide

QUICK-START GUIDE
BC
micro USB Jack
Trigger
Power
Cancel
selection
Accept
selection
Navigate the
menu
Battery
Charge
Indicator
Up / Down
Left / Right
Select laser or
thermal
modes
- Y (Yes)
- N (No)
Charge the battery,
and connect to PC
Capture
screenshots
Getting Started
1. Connect the supplied USB cable to
the micro USB jack, and to the USB
power supply adapter.
2. Connect the USB power supply
adapter to a live power source.
Your Thermal Laser is shipped with
a partial battery charge.
Fully charge the battery before use.
Charging
Charged
LED
Spotlight
Camera
Lens
Features
1. Press to select one of six
thermal views.
2. Hold trigger in and point laser at
object.
Laser Spot Temperature Mode
Thermal Mode
3. Release trigger to capture
screenshot, then press “Y” to save it.
1. Press until “Press TRIG to start
measurement” displays.
2. Point at object.
3. Pull trigger to capture screeenshot,
then press “Y” to save it.
On / Off
Laser
Thermal
Lens

Snap-On Thermal Laser Specifications

General

Brand	Snap-On
Model	Thermal Laser
Category	Diagnostic Equipment
Language	English