CERTIFICATION
This Snap-on VERSATORQ®2 was calibrated at factory using calibrated arms and weights that are
traceable to National Institute of Standards and Technology (N.I.S.T.). Testing parameters comply
with ISO 6789-2003 and ASME B107-28-2010.
MAINTENANCE / SERVICE
Clean Meter by wiping with a cloth. DO NOT use solvents, thinners or carburetor cleaners.
DO NOT immerse in anything.
Service, repair and calibration are to be done by Snap-on Service Centers only. Contact your
Snap-on Tools representative.
CALIBRATION
Contact your Snap-on sales representative for calibration services.
ATEX/UL CERTIFICATONS
IMPORTANT! Calibration events are recorded in memory which
provides evidence to void factory certification of compliance.
To Next Page
Loading...
