Snapper 1600 Series - Page 49

FIG. 6.8-TRACTION DRIVE-TWO CYL.
FIG. 6.11-ENGINE MOUNTING DETAIL
1. Traction Drive Belts. 2. Alternator Wiring. 1. Electric Clutch Wire. 2. Grounding Strap.
3. Clamp Bolt. 4. Pin. 5. Belt Tensioning Nuts. 3. Mounting Bracket Nuts. 4. PTO Drive Belts.
FIG. 6.9-TENSION BRACKET RETAINING CUP
13. Disconnect electric clutch wire (blue
wire) at right front of engine.
14. Remove front PTO drive belts.
15. Disconnect ground strap and remove
engine mounting bracket nuts at front of
engine.
16. Drain engine oil and remove drain
pipe.
17. Remove nuts at rear of engine mount¬
ing brackets.
18. Attach a suitable lifting device and
raise engine just enough to clear mounting
studs.
19. Slide traction drive tension bracket
from its pivot post while moving engine for¬
ward. Continue lifting engine clear
FIG. 6.10-DRIVE COUPLER & PIN FIG. 6.12-TRACTION DRIVE TENSION BRACKET
1. Twin Cylinder Engine Coupler. 2. Throttle Cable. 1. Drive Tension Bracket — Twin Cylinder.
6.5 W