EasyManua.ls Logo

Snapper 1696628 - User Manual

Snapper 1696628
56 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Briggs & Stratton Power Products Group, LLC • 12301 West Wirth St. • Wauwatosa • WI 53222
Printed In USA
Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL
BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
OperatOr’s Manual
Self Propelled Mower — Model 1696628 & 1696702
Form No. 769-11034
(September 24, 2015)
*Model 1696628 Shown

Table of Contents

Questions and Answers

  • D
    Daniel HowardAug 17, 2025
    How to fix Snapper Lawn Mower when engine fails to start?
    • M
      michael83Aug 17, 2025
      If your Snapper Lawn Mower engine won't start, several factors could be the cause. Make sure the blade control is engaged. Check that the spark plug boot is connected and the fuel tank has clean, fresh gasoline. If equipped, prime the engine as instructed or choke the engine. Other potential issues include a faulty spark plug (clean, adjust gap, or replace), a blocked fuel line (clean it), a closed fuel valve (open it), or a flooded engine (wait a few minutes to restart without priming).
  • P
    paulelizabethAug 22, 2025
    Why does my Snapper Lawn Mower engine run erratic?
    • T
      Tony SmithAug 22, 2025
      An erratic running engine in your Snapper Lawn Mower can be caused by a loose spark plug boot (connect and tighten it), a blocked fuel line or stale fuel (clean the fuel line and refill with fresh gasoline), a plugged vent in the gas cap (clear the vent), or water/dirt in the fuel system (drain and refill with fresh fuel). If your unit is running with the choke applied, push the choke knob in.
  • M
    mfrazierAug 25, 2025
    What to do if Snapper Lawn Mower fails to start with electric starter?
    • S
      sandrayangAug 26, 2025
      If your Snapper Lawn Mower with electric start fails to start, ensure the electric starter push key is fully inserted into the starter housing until it snaps into place. Also, check if the battery is charged. If the circuit breaker tripped, stop the engine, remove the electric starter key, and disconnect the spark plug boot. Clear any debris blocking the blade, then reattach the spark plug boot and key. Wait one minute for the breaker to reset before trying again.
  • D
    David PachecoAug 27, 2025
    What to do if Snapper Lawn Mower engine overheats?
    • M
      Mindy CastanedaAug 28, 2025
      If your Snapper Lawn Mower engine is overheating, first check the engine oil level and fill the crankcase with the correct oil if it's low. Also, ensure that there is no restriction to air flow. Clean the area around and on top of the engine.
  • D
    david50Aug 30, 2025
    Why Snapper 1696628 Lawn Mower has excessive vibration or noise?
    • G
      Gloria ScottAug 30, 2025
      Excessive vibration or noise in your Snapper Lawn Mower could be due to a loose or unbalanced cutting blade (tighten the blade and adapter, and balance the blade).
  • L
    Lance RobinsonSep 2, 2025
    Why Snapper 1696628 Lawn Mower will not mulch grass?
    • M
      Mrs. Judith HardingSep 2, 2025
      Your Snapper Lawn Mower may not mulch grass effectively if the grass is wet (avoid mowing when wet), if the grass is excessively high (mow at a high setting first, then at the desired height, or narrow the cutting path), or if the blade is dull (sharpen or replace it).
  • N
    Nancy TateSep 5, 2025
    Why Snapper 1696628 idles poorly?
    • J
      julierichardsonSep 5, 2025
      Poor idling in your Snapper Lawn Mower can occur if the spark plug is fouled, faulty, or has a gap that is too wide (reset the gap to .020” or replace the spark plug).
  • M
    Mr. Kevin JohnsonSep 7, 2025
    Why Snapper 1696628 has high pullback effort?
    • A
      arellanojohnSep 7, 2025
      High pullback effort on your Snapper Lawn Mower can happen if you're pulling it backwards before the transmission disengages. Allow the unit to roll forward slightly without the drive lever(s) engaged before pulling backwards. Also, the drive control may be adjusted too tight.
  • M
    Mrs. Andrea King DVMSep 10, 2025
    What to do if Snapper Lawn Mower will not self propel?
    • C
      Carlos RiveraSep 12, 2025
      If your Snapper Lawn Mower isn't self-propelling, check the belt for correct installation and movement on the pulley. Also, stop the engine, disconnect the spark plug boot, and remove any debris clogging the drive mechanism. Inspect the belt for damage or wear and replace if necessary.
  • K
    Kristi ParkerSep 12, 2025
    Why Snapper Lawn Mower has uneven cut?
    • E
      Evan CooperSep 12, 2025
      An uneven cut with your Snapper Lawn Mower is often caused by a dull blade. Sharpen or replace the blade.

Summary

Important Safe Operation Practices

General Operation Guidelines

Read, understand, and follow all instructions before operating. Exercise extreme caution.

Slope Operation Precautions

Use caution on slopes; avoid steep slopes and wet grass. Operate across slopes.

Children Safety

Keep children away from mower area. Never allow children under 14 to operate.

Safe Gasoline Handling

Handle gasoline with care due to flammability and explosive vapors.

General Service Safety Points

Safety Symbols Guide

Slope Gauge Instructions

Assembly and Set-Up

Handle Assembly and Adjustment

Cutting Height Adjustment

Drive Control and Handle Pitch Adjustment

Gas and Oil Fill-Up Procedure

Instructions for filling the engine with oil and gasoline before operation.

Controls and Features

Blade Control and Drive Controls

Explains operation of the blade control and drive engagement levers.

Speed Control and Recoil Starter

How to use the variable speed control and start the engine with the recoil starter.

Operation

Engine Oil and Fuel Recommendations

Guidance on selecting correct oil viscosity and fuel types for the engine.

High Altitude and Gas Hazard Information

Advice for high altitude operation and warnings about carbon monoxide.

Starting and Stopping the Engine

Procedures for safely starting and stopping the mower's engine.

Using Your Lawn Mower

Mulching and Grass Catcher Usage

Maintenance and Adjustments

General Maintenance Recommendations

Engine Care Schedule and Procedures

Recommended engine maintenance based on operating hours.

How to Change Engine Oil

Step-by-step guide for draining and refilling engine oil.

Servicing the Air Filter

Service

Blade Care and Maintenance

Battery Replacement and Charging

Off-Season Storage Preparation

Troubleshooting

Engine Start Issues

Solutions for problems when the engine fails to start.

Engine Operation Problems

Mower Performance Issues

Snapper 1696628 Specifications

General IconGeneral
EngineBriggs & Stratton
Engine Displacement163 cc
Deck MaterialSteel
Cutting Width21 inches
Start TypeRecoil
Cutting Height1.25-3.75 inches
Starting SystemRecoil
Warranty2-year limited

Related product manuals