Accessory - Thatcherizer
Footnotes:
TP 400-5143-3-WB-N
Manual No. 7006051A21" STEEL DECK WALK BEHIND MOWER
SERIES 7
41
Part No Descri
tionItem Qt
Note
-- 7061256 KIT, Thatcherizer (Includes items listed below) Recommended for propelled
models only.
1 7032891 2 ** LATCH, Frame Attachment
2A 7026572 1 BAR, Mount (Right Hand)
2B 7026573 1 BAR, Mount (Left Hand)
3 7018499 2 ROD, Tine
4 7018700 1 SUPPORT, Wheel
5 7019948 1 TRAY, Tine
6 7018496 6 KIT, Tine Thatching Spring Was 60574
7 7014100 1 ** BUSHING, Wheel Adjuster
8 7018493 1 ** AXLE, Wheel
9 7018189 1 WHEEL, 7.00 x 1.50 Gage
10 7091705 10 * NUT, 1/4-20 Hex Top Lock Was 90761, only 9 shown
11 7091294 4 * WASHER, 1/4” Flat Was 90055
12 7022425 2 ** SPRING, Compression
13 7090825 2 * BOLT, 1/4-20 x 1-1/4” Hex, GR 5
14 7091576 2 * NUT, 1/4-20 Hex, GR 5 Was 90063
15 7022424 2 ** CAP, Vinyl
16 7090015 2 * BOLT, 1/4-20 x 2-1/2” Square Neck Carriage only 1 shown
17 7091303 6 * BOLT, 5/16-18 x 1” Square Neck Carriage, GR 5 Was 90383, only 1 shown
18 7091530 2 * BOLT, 1/4-20 x 3/4” Square Neck Carriage, GR 5 Was 90074
19 7014098 6 * WASHER, Reinforcing (.343 I.D.) only 1 shown
20 7090187 6 * WASHER, 5/16” Split Lock only 1 shown
21 7091511 6 * NUT, 5/16-18 Hex, GR 5 Was 90196, only 1 shown
22 7014101 2 ** NUT, 1/2” Push
23 7014342 4 ** BEARING, Nyliner
24 7014103 1 ** SET SCREW, 5/16-18 x 1/4” slotted headless cup point
25 7090250 2 WASHER, 1/2” Flat
26 7014115 1 DECAL, Adjustment
27 7014062 1 DECAL, Thatcherizer
-- 7060554 1 NLA - HARDWARE BAG, Thatcherizer 21” (Std.) Not shown
-- 7060555 1 NLA - HARDWARE BAG, Thatcherizer 21” (Special) Not shown
-- 7026700 1 MANUAL, Operator's (61256) Not shown
* Included in Hardware Bag # 60554
** Included in Hardware Bag # 60555
To Next Page
Loading...
