Using a saw, cut off top crate (a) fi rst, then cut crate
away from bottom pallet (b).
IMPORTANT NOTE: When cutting crate from bottom
pallet, use caution around tractor tires.
Uncrating
a
b
Note: Apply anti-seize lubricant to the steering shaft.
Then install steering wheel with center spoke facing
down.
Assemble Steering Wheel
Removing Tractor from
Shipping Pallet
Important: The hydraulic attachment lift and power
steering will not operate when the brake pedal is
engaged. Releasing the brake pedal restores operation.
Important: When the engine is not running, steering
ability is reduced. The tractor can still be maneuvered
by slowly turning the steering wheel.
1. Check to be sure there are no nails or sharp
objects on bottom of skid to puncture the tractor
tires.
2. Place a board in front of the pallet to act as a
step while unloading the tractor.
3. Place mower in the highest height of cut position.
4. Pull the roll release lever until it locks in the
release position.
5. Tap the brake pedal to release the parking brake.
6. Attach a strap or rope on axles as shown.
7. Pull the tractor off the skid with a second person
guiding it.
8. After moving the tractor, re-engage the roll
release lever by pushing the lever into the drive
position.
1
7
6
2
5
+
6
5
4
3
2
1
3
4
8
ANTI-SEIZE
20 lb-ft (27 Nm)
1
2
3
4
15/16
2
To Next Page
Loading...
Need help?
General
