Snapper Lawn Mower - User Manual

1
SET-UP INSTRUCTION & PRE-OPERATION CHECKLIST
SNAPPER 21" STEEL DECK COMMERCIAL RECYCLING WALK MOWERS
INTRODUCTION: The SNAPPER Walk Behind Mowers are shipped almost fully assembled and require minimal
set-up. Complete each of the following steps carefully. Review and complete each item as instructed on the
Pre-Operation checklist. The Snapper Product Registration card must be filled out and sent to Customer
Service department at Snapper when completed.
WARNING – DO NOT ATTEMPT TO START OR
OPERATE THIS UNIT UNTIL ALL ASSEMBLY
STEPS HAVE BEEN COMPLETED. SERIOUS
INJURY OR EQUIPMENT DAMAGE MAY RESULT.
HANDLE ASSEMBLY
STEP 1: Remove mower from shipping carton. These
mowers are manufactured with (4) 5/16-18 x 2” hex cap
screws, and (4) 5/16 bolt retainers that secure the
upper, middle handles and lower handle brackets
together for packaging purposes. This hardware will
have to be removed and discarded. See Figure 1.
REMOVE EXISTING HARDWARE
FIGURE 1
STEP 2: New hardware can be found in hardware bag.
Attach middle handle to lower handle brackets using
5/16-18 x 2” curved head bolts, installed from the inside
of handles as shown, and secure with 5/16 internal
tooth lock washers and hex nuts. Do Not tighten at this
time. See Figure 2.
STEP 3: Attach the upper handle assembly to the middle
handle using 5/16-18 x 1-1/2” curved head bolts,
installed from the inside of handles as shown, and
secure with 5/16 internal tooth lock washers and hex
nuts. Do Not tighten at this time. See Figure 3.
FIGURE 2
FIGURE 3
FIGURE 4
INSTRUCTION No. 7100374 (I.R. 1/11/2006)
TP 300-5113-IR-CW-N
UPPER
HANDLE
MIDDLE
HANDLE
5/16 BOLT
RETAINER
5/16 BOLT
RETAINER
5/16 X 1-1/2” MACHINE
SCREWS
5/16 X 2” HEX
HEAD CAP
SCREWS
MIDDLE
HANDLE
5/16 BOLT
RETAINER
LOWER
HANDLES
MIDDLE
HANDLE
LOWER
HANDLE
(Left Side)
5/16 X 2”
CURVED
HEAD BOLT
5/16 HEX
NUTS
5/16 LOCK
WASHERS
UPPER
HANDLE
MIDDLE
HANDLE
INTERNAL
TOOTH LOCK
WASHER
5/16 X 1-1/2”
CURVED
HEAD BOLTS
HEX NUT
LOWER HANDLE
BRACKET
LOOSEN
THREE NUTS

Summary

Handle Assembly

Remove Existing Hardware

Instructions for removing packaging hardware from the mower handles.

Drive Assembly

Driven Disc and Ground Speed Control

Steps for adjusting the driven disc and installing the ground speed control rod.

Clutch Cable Adjustment

Discharge Assembly and Grass Bag Installation

Side Discharge Deflector

Instructions for installing the side discharge deflector.

Grass Bag

Steps for installing the grass bag adapter and bag.

Pre-Operation Checklist

Setup Verification

Checks for handle security, rope guide, console, drive assembly, and blade.

Lubrication Checks

Verification of engine oil and differential grease levels.

Operational Tests

Tests for engine start, wheel drive, and ground speed control.

CPSC Compliance Test

Ensuring blade control stops the engine when released.

Snapper Lawn Mower Specifications

General

Brand	Snapper
Model	Lawn Mower
Category	Lawn Mower
Language	English