Snapper TUFF TORQ K50 - Section II - TROUBLESHOOTING.2.1-2.2

Section II - TROUBLESHOOTING
HYDROSTATIC TRANSAXLE
TRANSAXLE WILL NOT MOVE FORWARD OR IN REVERSE
Roll release lever is engaged.
Oil level low.
Input drive beit is slipping or broken.
Parking brake is set.
Stripped splines on input shaft.
Stripped keys on axles.
Broken axle or ring gear.
disengage iever
add oil
adjust/replace belt
release park brake
replace input shaft
repiace axie keys
repiace axle or ring gear
TRANSAXLE IS OVERHEATING
Oil level low.
Oil is of wrong type.
Cooiing fins on transaxie are clogged
Broken cooling fan blades.
Exceeding ioad rating for tractor. . .
Parking brake not fuiiy released . . .
check/add oil
drain, replace with specified oil
clean fins
repiace cooiing fan
reduce load
release park brake
LEAKING OIL
...from axle seals.replace axle seals and/or bushings
...from oil breather.overfilled, drain excess oil
FREEPLAY IN SHIFTER ARM
Shift blocks probably worn . .
check/replace shift blocks