Snooper S5100 - User Manual

PLEASE NOTE
Due to our desire to continually improve our products, the specication may change without notice.
The Micro-SD Card comes complete with digital mapping and is also where the
AURA™ camer
a database is stored if you choose to subscribe and download it.
Switch on the device by pressing and holding the standby power button located
on the top of the unit for 2 seconds. The Snooper will automatically synchronise
with the Micro-SD Card. Once the synchronisation is completed, the Micro-SD Card
will not function with any other device. Snooper is now ready to navigate and the
camera database can be downloaded if necessary. NOTE: In most cases the Micro-
SD card is already installed in the device.
Refer to page 3 for additional , important, MicroSD card guidence.
Please note that if the unit does not activate when you press and hold the standby power button for 2 seconds it may require
charging. Refer to the section ‘Charging the internal battery’ later in this manual.
What’s included?
1 x Snooper satellite navigation system
1 x Micro-SD Card - Mapping
1 x 8GBMicroSD card - DVR - SC5800 and SC5900 DVR only
1 x Windscreen Mounting Bracket
1 x Active magnetic mount - S6900 ONLY
1 x Protective case - except S2700
1 x In-Vehicle Charger and TMC cable combined - S6800, S8100, S6900, SC5800 and S5C900 ONLY
1 x TMC antenna with jack connector - S2700, S6810 and S8110 Only
1 x USB download Cable
1 x 3.5mm to RCA video cable ( for reversing camera - not included) except S2700
1 x Mounting disk for dash mounting the bracket - except S2700 and S6900
PLEASE NOTE: Due to our desire to continually improve our products, the specification may change without notice.
Start UP
Navigation Quick Start Guide
For S2700, S5100, S68xx, S6900, S81xx, SC5900, SC5800
and variants
Bus/Coach, Car, Truckmate and Ventura
1 of 10
QSG EN v1.1 11/19

Summary

Getting Started

Whats Included

Lists all items included in the Snooper satellite navigation system package.

Initial Power On

How to switch on the device by holding the standby power button for 2 seconds.

Charging Advisory

Guidance on potential charging requirements if the unit does not activate upon initial power-on.

Installation

Windscreen Mounting

Instructions for mounting the Snooper using the windscreen suction cup bracket.

Dashboard Mounting Disk

Steps to install the Snooper using the provided dashboard mounting disc.

Power and Charging

Cigarette Lighter Power

Connect the power cable to the unit and cigarette lighter socket for power and charging.

Internal Battery Charging

Connect the device to power to charge the internal battery; notes on battery performance.

Navigating with Snooper

GPS Acquisition and Menu Access

Acquire GPS signal by taking the device outside, then touch display centre to access navigation menu.

Entering Destination

Enter destination postcodes using the on-screen keyboard and press OK to proceed.

Route Calculation and Summary

Calculate the fastest route and view the journey summary before turn-by-turn guidance begins.

Turn-by-Turn Guidance

Follow on-screen and voice instructions for navigation, including automatic re-routing.

Vehicle Setup and Parameters

Vehicle Parameters Configuration

Configure vehicle height, weight, and dimensions for optimized routing, saving up to 10 profiles.

Load and Tunnel Restrictions

Configure load types and ADR tunnel categories for specific vehicle restrictions.

Advanced Settings

Environmental Settings (LEZ)

Set vehicle emissions standards and parameters to comply with Low Emission Zones.

TMC Traffic Information

Understand TMC technology and the importance of antenna positioning for traffic alerts.

Snooper S5100 Specifications

General

GPS	Yes
Speed Camera Alerts	Yes
Display Resolution	480 x 272 pixels
Camera	No
Laser Alerts	No
Display Size	5 inches
Display Type	LCD
Battery	Rechargeable lithium battery