The default access level is 3.
In this level only viewing of data is allowed.
STOP: If you are not a trained technician do
not use Technician Mode in Access level 1 or
2. Death or serious injury can result from
unauthorized adjustments and setups.
Access level 2 is required to make adjustments to
values and to make calibrations.
Access level 1 is required to make adjustments to
values, calibrations, and change setups.
Access Codes to change between Access Levels
prevent inadvertent adjustments.
page
14 Rev A S3970RT, S3370RT, &
S2770RT – 1441817
Control System Information
To Next Page
